Werbung
EN
Remove the battery pack from the machine before
maintenance.
9.1
CLEAN THE MACHINE
Keep the machine and the motor free of leaves, branches or
excessive oil to prevent fire risks.
•
Use a moist cloth with a mild detergent to clean the
machine.
•
Clean all moisture with a soft dry cloth.
•
Use a small brush to clean the air vents.
9.2
LUBRICATE THE BLADE
Figure 7
To increase the efficiency and life of the blades, lubricate
them carefully after each work session:
•
Put the machine on a flat and smooth surface.
•
Use a soft cloth to clean the blades and a brush to remove
more dirt.
•
Use a light layer of oil to lubricate the blades along the
top edge of the blade.
We recommend to use the non-pollutant type oil.
10
STORE THE MACHINE
Clean the machine before storage.
1. Remove the battery pack.
2. Let the motor cool.
3. Check that there are no loose or damaged components. If
it is necessary, replace the damaged components, tighten
screws and bolts, or speak to a person of an approved
service center.
4. Store the machine in a cool and dry location.
11
TROUBLESHOOTING
Problem
The motor does
not start when you
pull the trigger.
English Original Instructions
WARNING
WARNING
NOTE
NOTE
Possible cause
Solution
Make sure that
The battery pack is
you tightly install
not installed tight-
the battery pack in
ly.
the machine.
The battery pack is
Charge the battery
out of power.
pack.
Problem
Possible cause
The machine
The machine has
smokes during op-
damage.
eration.
The motor is on,
The machine has
blade do not
damage.
move.
The blades are
blocked.
The parts are
There is too much
loose.
noise and/or vibra-
tion during opera-
tion.
The parts have
damage.
12
TECHNICAL DATA
Voltage
Blade speed
Cutting length
Weight (without battery
pack)
Measuered sound pressure
level
Measured sound power level 95dB(A), KWA=3dB(A)
Guaranteed sound power lev-
el
Vibration
Uncertainty
Battery model
Charger model
13
EC DECLARATION OF
CONFORMITY
Manufacturer:
YAMABIKO CORPORATION
Address:
1-7-2 Suehirocho, Ohme, Tokyo 198-8760
JAPAN
8
Solution
1. Immediately
stop the ma-
chine.
2. Remove the
battery pack.
3. Speak to your
dealer.
Do not use the ma-
chine and speak to
your dealer.
1. Stop the ma-
chine.
2. Remove the
battery.
3. Inspect for
damage.
4. Check and
tighten loose
parts.
Do not use the ma-
chine and speak to
your dealer.
36 V DC, 40 V max
3000(±10%) cuts/min
604 mm
2.7 kg
82dB(A), KPA=3dB(A)
98dB(A)
<2.5 m/s2
1.5 m/s2
LBP-36-80 / LBP-36-150
LC-3604
Werbung
