Setup; Installation; Sound-Control; Dmx-Connection Between The Devices - EuroLite DMX LED Operator 1 Bedienungsanleitung

5. SETUP

5.1 Installation

As this device was designed for standing operation, please install the device on a plane surface.

5.2 Sound-control

The sound-control works via the built-in microphone.

5.3 DMX-Connection between the devices

The wires must not come into contact with each other, otherwise
the fixtures will not work at all, or will not work properly.
Only use a stereo shielded cable and 3-pin XLR-plugs and connectors in order to connect the controller with
the fixture or one fixture with another.
Occupation of the XLR-connection:
You can adjust the XLR polarity via the DMX POLARITY selector.
Building a serial DMX-chain:
Connect the DMX-output of the Stage Control 136 with the DMX-input of the nearest dimmerpack. Always
connect one output with the input of the next fixture until all fixtures are connected.
Caution: At the last fixture, the DMX-cable has to be terminated with a terminator. Solder a 120 resistor
between Signal (–) and Signal (+) into a 3-pin XLR-plug and plug it in the DMX-output of the last fixture.

5.4 Addressing the devices

The devices to be controlled need to be assigned the DMX starting address The starting address is defined
as the first channel from which the devices will respond to the controller.
Please assign the starting address 1 to the devices. Now you can start operating them via your DMX LED
Operator 1.

6. OPERATION

Connect the connection cable of the power-unit with the DC IN-socket. Plug the power unit into your outlet.
After you connected the device to the mains, the DMX LED Operator 1 is ready for use.

6.1 Select Color-Mode

In the Select Color-Mode, you can call up the individual colors manually via the color buttons under „Hold
Colors" as well as via the channel faders (R, G, B).
Press the COLOR SELECT-button - the D2-LED lites up green.
Press the button of the desired color.
12/14 00041883.DOC, Version 1.1