BRAYER BR4010 Bedienungsanleitung Seite 9

• Set the necessary steam intensity with the
continuous steam supply knob (3): steam will be
released from the openings of the soleplate (12) only
if the iron is in horizontal position. To stop the steam
supply, put the iron vertically or set the knob (3) to
the position « » (steam supply is off).
• After you finish ironing, set the temperature control
knob (13) to the position «MIN», and the continuous
steam supply knob (3) to the position «
supply is off).
• Disconnect the power plug from the mains socket
and wait until the iron soleplate (12) cools down
completely.
ATTENTION! If steam is not supplied during the
operation, check whether the temperature control knob
(13) and the steam supply knob (3) are set properly and
whether there is water in the water tank (11).
WATER SPRAY
• Make sure that there is enough water in the water
tank (11).
• Press the water spray button (5) to dampen the
fabrics.
BURST OF STEAM
• The burst of steam is useful for ironing folds and can
be used only in the high temperature ironing mode;
set the temperature control knob (13) to the position
«•••» or «max».
• When pressing the burst of steam button (4) steam
will go out of the iron soleplate (12) openings
intensively.
Note: to avoid water leakage from the soleplate (12)
openings, press the burst of steam button (4) with 4-5
sec. intervals.
VERTICAL STEAMING
• Vertical steaming of fabrics or interior objects can be
» (steam
performed only in the high temperature ironing mode.
Set the temperature control knob (13) to the position
«•••» or «max»).
• Hold the iron vertically at the distance of 5-20 cm
from the clothes or interior objects and press the
burst of steam button (4) with 4-5 second intervals,
steam will be released from the soleplate (12)
openings intensively.
ATTENTION!
- To avoid fabric melting, do not touch it with the iron
soleplate (11) while steaming.
- Do not steam clothes on a person. Use a clothes
hanger or a coat rack.
• After you finish ironing, switch the iron off and unplug
it, wait until the iron soleplate (12) cools down
completely, then open the water inlet lid (2), turn over
the iron and drain the remaining water.
STEAM CHAMBER CLEANING
• Regularly clean the steam chamber of the iron,
especially in the regions with «hard» tap water.
EN 9