NEC MultiSync E244FL-BK Installationsanweisung Seite 11

Please install the product in accordance with the following information.
When transporting, moving, or installing the product, please use as many people as necessary
to be able to lift the product without causing personal injury or damage to the product.
Please refer to the instructions included with the optional mounting equipment for detailed
information about attaching or removing.
Do not cover the vent on the product. Improper installation of the product may result in
damage to the product, an electric shock or fire.
Do not install the product in the locations below:
REQUIRED
• Poorly ventilated spaces.
7
• Near a radiator, other heat sources, or in direct sunshine.
• Continual vibration areas.
• Humid, dusty, steamy, or oily areas.
PROHIBITED
• Outdoors.
• High-temperature environment where humidity changes rapidly and condensation is likely
to occur.
Do not mount the product in any configuration or position not described in the user's manual.
Please check the Specifications for the available Tilt range when installing the product.
Prevent tipping and falling for earthquakes or other shocks.
To prevent personal injury or damage to the product caused by tipping over due to
earthquakes or other shocks, make sure to install the product in a stable location and take
measures to prevent falling.
• The product must be mounted to an approved flexible arm (e.g. TUEV GS mark) or stand
that supports the weight of the product to prevent damage and personal injury that could
result from the product tipping over or falling.
• Only use the screws that were removed from the product's stand or the specified screws to
avoid damage to the product or the stand.
• Please tighten all screws (Recommended Fasten Force: 98 - 137 N•cm) when installing
the product to a flexible arm or stand. A loose screw may cause the product to fall, causing
damage to the product or personal injury.
• Attaching the flexible arm should be performed by two or more people if the product cannot
be placed face-down on a flat surface for installation.
Stability Hazard.
The product may fall, causing serious personal injury or death. To prevent injury, this product
must be securely attached to the floor/ wall in accordance with the installation instructions.
Many injuries, particularly to children, can be avoided by taking simple precautions such as:
PROHIBITED
• ALWAYS use stands or installation methods recommended by the manufacturer of the
8
product set.
• ALWAYS use furnitures that can safely support the product.
• ALWAYS ensure the product is not overhanging the edge of the supporting furniture.
REQUIRED
• ALWAYS educate children about the dangers of climbing on furniture to reach the product
or its controls.
• ALWAYS route cords and cables connected to your product so they cannot be tripped over,
pulled or grabbed.
• NEVER place a product in an unstable location.
• NEVER place the product on tall furniture (for example, cupboards or bookcases) without
anchoring both the furniture and the product to a suitable support.
• NEVER place the product on cloth or other materials that may be located between the
product and supporting furniture.
• NEVER place items that might tempt children to climb, such as toys and remote controls, on
the top of the product or furniture on which the product is placed.
• ALWAYS use wall mounting accessories when installing the product at a high location.
NEVER place the product on a monitor stand when installing the product at a high location.
If the existing product is going to be retained and relocated, the same considerations as above
should be applied.
WARNING
English-3
EN