Selve SEZ Originalbetriebsanleitung Seite 34

Setting of the end positions
Step 4
or Push and hold the button.
• Change lower end position
or
• Change upper end position
The motor moves away from the end position and stops on its own.
Step 5
or Move to the new end position with UP or DOWN. Correction is possi-
ble.
Note: Only in this programming step there will be no automatic deacti-
vation!
• Change lower end position
or
• Change upper end position
Step 6
or
• Change lower end position
or
• Change upper end position
Push and hold the DOWN button.

Push and hold the UP button.

Do not coil the fabric the wrong way

around.
D o not move the drop rod against the

fabric shaft.
Push and hold the UP button and run

without interruption until the motor
switches off on its own in the upper end
position.
Push and hold the DOWN button and

run without interruption until the
motor switches off on its own in the
lower end position. Done!
34