Pkm GSP12-6FI Bedienungsanleitung Seite 75

 Unsuitable detergent.
 Spilled rinse aid.
 Detergent contains colorants.
1. Unsuitable programme.
2. Dishes are placed improperly.
 Extremely hard water.
 Very low temperature of the water
supply.
 Appliance is overfilled.
 Dishes are placed improperly.
 Old or wet pulvered detergent.
 Rinse aid container is empty.
 Improper detergent dosage.
 Soft water in combination with too
much detergent.
1. Tea or coffee stains.
2. Iron deposits in the water.
 Minerals in hard water.
Foam in the appliance.
Stained interior.
Dishes are not clean.
Spots and film on glasses and cutlery.
Cloudiness on glassware.
Yellow or brown film on inner surfaces.
White film on inner surfaces.
regularly, let it operate once a week.
 Use dishwasher detergent only.
Open the door and wait until the
foam has evaporated. Pour approx. 4
litres of water in the appliance. Close
the door and select the pre-wash
programme. Repeat procedure if
need be.
 Use colorant-free detergents.
1. Select a stronger programme.
2. Check the position of the dishes.
The dishes must not block the spray
arms.
To remove spots from glassware:
1. Remove all metal-made objects.
2. Do not use a detergent.
3. Select the longest programme.
4. Start the programme. After 18-22
minutes the main-wash cycle begins.
5. Open the door pour 2 cups of white
vinegar in the appliance (bottom).
6. Close the door and let the complete
programme run. If this measures fail,
repeat the procedure but use 1/4
cup (60 ml) of citric acid crystals
instead of the vinegar.
 If you have soft water, use less
detergent. Select a short programme
for glassware.
1. Clean with a solution of 1/2 cup of
bleach and 3 cups of warm water.
Clean by hand.
2. You need a special filter. Contact a
local water installation company.
 Clean the interior with a soft sponge
and dishwasher detergent. Wear
75