SCHUBERTH F130 Bedienungsanleitung Seite 11

• It is also possible for the material structure of the helmet to be damaged
but the damage not to be visible (after a minor collision or impact). You
can check this by performing a thumb pressure test on the shell: If the shell
can be pressed in with the thumb at the affected point or at any other
point (so-called indicator function), the helmet must be replaced and made
unusable, since the shell structure has undergone a change in resistance.
• The painted surface of the helmet must be checked for damage, since
the self-extinguishing special lacquer structure is an important thermal
performance factor, and damage to the lacquer may reduce the service life
of the helmet. Small scratches on the surface do not reduce the protective
function of the helmet.
• If there is damage to the helmet that has been caused by high thermal
impacts or direct contact with chemicals (these can sometimes be identified
by colour changes or damage to the shell lacquer), the helmet must not be
used.
• Attention: In principle the helmet must no longer be used after an impact,
severe blow, or any other force effects. This applies even if there is no visible
external damage.
• Attention: Because the shock-absorbing parts of the interior are exposed
to nonvisible forces, we recommend that the helmet is preventively
replaced after 15 years.
Warranty
SCHUBERTH provides a warranty for the helmet of two (2) years from the
date of purchase, which covers material and workmanship. The liability of
SCHUBERTH shall be limited to either the repair or replacement, at its option,
of products that are proven to be defective within the warranty period. The
helmet must not differ from its original condition and/or must not have been
damaged by improper use.
Maintenance
The helmet must undergo regular maintenance. The user can carry out
replacements of SCHUBERTH original parts from spare parts and accessories
listed in the instructions. Any further repairs are only to be carried out by
trained personnel or the SCHUBERTH Service Centre.
20
Storage and transport
Firefighter helmets should be stored in a cool, dry and protected place. Even
though the helmet shell is resistant to UV rays, keep your helmet away from
direct sunlight when stored in order to prevent possible damage to the luminous
lacquer. In normal use, we recommend leaving the visor mounted on the helmet
when storing. In all cases avoid storage near aggressive substances such as sol-
vents and fuels. The helmet can be transported in its box if adequately wrapped
in bubble wrap.
Spare parts and accessories
Spare parts
3990000081 Head support ring (with eco-leather sweatband)
9300100520 Inner netting with retainers
3990000415 Leather sweatband (eco-leather, black) with felt strips (set = 10 pcs.)
9300105620 Chin-neck strap
3990000180 Fastening screw set
(replacement screws + screw nuts + seal sleeves)
3990000215 Chin strap screw set (includes 2 nuts (Nirosta) + 2 screws)
9041400205 Reflective tape, silver for F130 H3
9041400209 Reflective tape, silver for F130 H2
Accessories
9040030700 Neck protector NPH1 Classic (leather, black, with strap)
9040030705 Neck protector NPH1 Silver pro (aluminized, with strap)
9040030710 Neck protector NPH1 Nomex® (with strap)
9049100002 Nomex neck collar (shroud) HTS1 (with strap)
3990000310 Visor bracket HF1 Size 2
3990000320 Visor bracket HF1 Size 3
3990000315 Replacement milled nuts for visor holder HF1 (Set = 10 pcs.)
3990000840 Visor VF1-HighTemp Standard
3990000810 Visor VF1-Rescue Standard
21