Velleman CAMCOLBUL22 Bedienungsanleitung Seite 4

do not aim the camera at the sun or other extremely bright objects or reflections (e.g. metal
o
doors).
The connection cables run at the inside of the mounting bracket, and leave at the backside [3]
o
(default). They can be re-guided to leave via the top [4] or bottom [5] of the mounting
bracket.
Note that the camera must be resting on top of the mounting bracket.
o
•
When the cables go through the wall:
[B] Use the wall mounting bracket to determine and indicate the position of the mounting
o
holes.
When the connection cables need to go through the wall, a hole of at least Ø10mm (max.
o
Ø35mm) must be foreseen at the mounting location, close to the centre of the drawn template.
•
Mount the mounting bracket on the wall using 4 screws (included).
•
Guide the connection cable into the mounting bracket and guide the connector out through the
desired hole ([3], [4] or [5]). Never exert excessive stress on the connection cable to avoid
damage. Rotate the camera to the desired angle and place the camera on the mounting bracket
making sure there is no stress on the connection cable.
•
Tighten hex screw [7] to secure the horizontal position and hex screw [6] for the vertical
position.
•
[C] Connect the connection cable with the BNC/power adaptor cable [Y]. This is only possible in
one way; do not force. Use some waterproof tape (not inc.) to make the connection completely
watertight.
•
Connect the video connector [1] to a monitor (not incl.).
•
Connect the power connector [2] to a 12VDC power supply (not incl.).
•
The sunshield can be mounted or dismounted by releasing the two screws on top of the camera
and sliding it towards the rear.
7. Technical specifications
pick-up element
number of pixels
resolution
min. Illumination
S/N ratio
electronic shutter
gamma correction
white balance
AGC
standard board lens
lens angle
video output
power supply
consumption
IP-rating
IR LEDs
max. IR projection distance
dimensions
weight
operating temperature
Use this device with original accessories only. Velleman nv cannot be held responsible
in the event of damage or injury resulted from (incorrect) use of this device. For more
info concerning this product, please visit our website www.velleman.eu. The
information in this manual is subject to change without prior notice.
© COPYRIGHT NOTICE
This manual is copyrighted. The copyright to this manual is owned by Velleman nv. All worldwide rights reserved.
No part of this manual may be copied, reproduced, translated or reduced to any electronic medium or otherwise without
the prior written consent of the copyright holder.
19.10.2009
CAMCOLBUL22
1/3" HR colour CCD
752(H) x 582(V) - PAL -
520 TV lines
0.1 Lux (F2.0); 0 Lux (IR on)
> 48dB (AGC off)
1/50 to 1/100000 sec
0.45
automatic
yes
f6.0mm/F2.0
54°
1.0Vpp composite, 75 ohms
12VDC ± 10% (regulated, use PS1205R, not incl.)
70mA (IR off), 675mA (IR on)
IP67
56
40m
Ø115.6 x 216.4mm
1350g
0°C to +40°C
4
©Velleman nv