JUNO JCF102F0S3 Benutzerinformation Seite 14

Problem
The appliance is noisy.
The compressor operates contin‐
ually.
Door is misaligned or interferes
with ventilation grill.
Door does not open easily.
The lamp does not work.
There is too much frost and ice.
Water flows on the rear plate of
the refrigerator.
14 ENGLISH
Possible cause
There is no voltage in the mains
socket.
The appliance is not supported
properly.
Temperature is set incorrectly.
Many food products were put in
at the same time.
The room temperature is too
high.
Food products placed in the ap‐
pliance were too warm.
The door is not closed correctly.
The appliance is not levelled.
You attempted to re-open the
door immediately after closing.
The lamp is in stand-by mode.
The lamp is defective.
The door is not closed correctly.
The gasket is deformed or dirty.
Food products are not wrapped
properly.
Temperature is set incorrectly.
Appliance is fully loaded and is
set to the lowest temperature.
Temperature set in the appliance
is too low and the ambient tem‐
perature is too high.
During the automatic defrosting
process, frost melts on the rear
plate.
Solution
Connect a different electrical ap‐
pliance to the mains socket. Con‐
tact a qualified electrician.
Check if the appliance stands
stable.
Refer to "Control panel" chapter.
Wait a few hours and then check
the temperature again.
Refer to "Installation" chapter.
Allow food products to cool to
room temperature before storing.
Refer to "Closing the door" sec‐
tion.
Refer to installation instructions.
Wait a few seconds between
closing and re-opening of the
door.
Close and open the door.
Refer to "Replacing the lamp"
section.
Refer to "Closing the door" sec‐
tion.
Refer to "Closing the door" sec‐
tion.
Wrap the food products better.
Refer to "Control panel" chapter.
Set a higher temperature. Refer
to "Control panel" chapter.
Set a higher temperature. Refer
to "Control panel" chapter.
This is correct.