Defrosting Of The Freezer; Troubleshooting - JUNO JCF102F0S3 Benutzerinformation

7.4 Defrosting of the freezer

CAUTION!
Never use sharp metal tools to scrape off
frost from the evaporator as you could
damage it.
Do not use a mechanical device or any
artificial means to speed up the thawing
process other than those recommended
by the manufacturer.
About 12 hours prior to defrosting set
a lower temperature in order to build up
sufficient chill reserve in case of any
interruption in operation.
A certain amount of frost will always form on
the freezer shelves and around the top
compartment.
Defrost the freezer when the frost layer
reaches a thickness of about 3-5 mm.
1. Switch off the appliance or pull out
electrical plug from the wall socket.
2. Remove any stored food and put it in a
cool place.
CAUTION!
A temperature rise of the frozen food
packs during defrosting may shorten
their safe storage life.
Do not touch frozen goods with wet
hands. Hands can freeze to the
goods.

8. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
8.1 What to do if...
Problem
The appliance does not operate.
3. Leave the door open. Protect the floor
from the defrosting water e.g. with a cloth
or a flat vessel.
4. In order to speed up the defrosting
process, place a pot of warm water in the
freezer compartment. In addition, remove
pieces of ice that break away before
defrosting is complete.
5. When defrosting is complete, dry the
interior thoroughly.
6. Switch on the appliance and close the
door.
7. Set the temperature regulator to obtain
the maximum coldness and run the
appliance for at least 3 hours using this
setting.
Only after this time put the food back into the
freezer compartment.
7.5 Period of non-operation
When the appliance is not in use for long
period, take the following precautions:
1. Disconnect the appliance from electricity
supply.
2. Remove all food.
3. Defrost the appliance.
4. Clean the appliance and all accessories.
5. Leave the doors open to prevent
unpleasant smells.
Possible cause
The appliance is switched off.
The mains plug is not connected
to the mains socket correctly.
Solution
Switch on the appliance.
Connect the mains plug to the
mains socket correctly.
ENGLISH 13