Christopeit Sport AL2 Montage- Und Bedienungsanleitung Seite 24

CLEANING, CHECKS AND STORAGE
1. Cleaning
Use only a less wet cloth for cleaning. Attention! Never use benzene, thinner or other aggressive cleaning agents for surface
cleaning as this damage caused. The device is only for private home use and for use suitable indoors. Keep the unit clean and
moisture from the device.
2. Storage
Plug out the power supply unit while intending the unit for more than 4 weeks not to use. Push the saddle slide toward the
handlebar and the seat support tube as deeply as possible into the frame. Choose a dry storage in-house and put some spray oil to
the pedal bearings left and right, to the thread of the handlebar bolt, and on the thread of the quick release for saddle support.
Cover the bike to protect it from being discolor by any sunlight and dirty through dust.
3. Checks
We recommend every 50 hours to review the screw connections for tightness, which were prepared in the assembly. Every 100
operating hours, you should put some spray oil at the pedal bearings left and right, to the thread of the handlebar bolt and to the
thread of quick release for saddle support.
TROUBLESHOOTING
If you cannot solve the problem with the following information, please contact the authorized service center.
Problem
Computer has no value at
Display if you press any key.
Computer is not counting data
and do not switch on after start
cycling.
Computer is not counting data
and do not switch on after start
cycling.
No pulse value
No pulse value
Possible Cause
No power adapter is well plugged or wall
power is without power.
Sensor impulse missing base on not well
plugged connection
Sensor impulse missing base on not
correct position of sensor.
Pulse cable is not plugged in.
Pulse sensors not well connected.
Solution
Check that the power adapter is properly plugged in, possibly
with another electric device check if the wall power is fine.
Check the plug connections at computer and inside of handlebar
support.
Take off the cover and check the distance between magnet and
Sensor. The magnet at turning belt wheel should have only less
than < 5mm distance against the sensor position.
Check the separately pulse cable is well connected with
computer.
Screw out the screw for pulse measurement and check if plugs
are well connected and no damage at pulse cable.
24
GB