GOK CN60/M Montage- Und Bedienungsanleitung Seite 9

Inlet, optional
Outlet, optional
All G. and H. connections according to EN 16129. Other connections may also be used.
ASSEMBLY
Before assembly, check that the product is complete and has not suffered any damage
during transport. ASSEMBLY must be carried out by a specialised company.
Screw connections
If connections leak, there is a danger of explosion, fire or suffocation!
Gas may escape if the product is turned.
Do not turn the product after it has been installed and the connections have been
tightened.
Tighten connections only when they are not pressurised.
Metal chips may cause eye injuries.
Wear safety goggles!
Part no. 01 219 50 d
Trading name and dimensions
acc. to standard
Large cylinder connection (GF)
• with aluminium gasket
• G.4 = Thread W 21.8 x 1/14 lh
Combinded fitting (Komb.A)
• with polyamide gasket
• G.5 = Thread W 21.8 x 1/14
Small cylinder KLF (KLF)
• with 5-wing cap nut
• G.12 = Thread W 21.8 x 1/14 ÜM
Compression fitting RVS
• G.15 = RVS 8
Trading name and dimensions
acc. to standard
Ball-cone connector
• H.4 = Thread G 1/4-LH-KN
Ball-cone connector
• H.6 = Thread G 3/8 lh M
Compression fitting RVS
• H.9 = compr. fit 8 or compr. fit 10
Risk of injuries due to blown-out metal chips!
Medium pressure regulator Type CN60/M
Installation notes
Spanner size 30
Hexagonal
Spanner size 30
Hexagonal
Installation notes
Torques:
G 1/4 = 5-7 Nm
Torque:
G 3/8 = 15 Nm
3 / 6