Wp 50H / Wp 75H; Manual Operation; Pneumatic Operation - HOLZMANN-MASCHINEN WP50H Originalbetriebsanleitung

14 OPERATION
Before starting work:
 General technical condition of the machine
 Safety devices in place and in order
Property damage and injuries caused by shooting up and off of the workpiece
possible!
Therefore:
Workpiece always Backup and safety radius keep the machine and workpiece

quality check and note
WARNING! Make sure that you understand the basic operation of a shop press. Consult an ap-
propriate professional or visit the training if you orderly use of a shop press not know or under-
stand!
Make sure that the entire platen rests on the frame and is not held by the winds. The
winch must be loosened and the winch cable must be loose.

14.1 WP 50H / WP 75H

Place the V-prism blocks on the press table. Then, place the workpiece on the V-prism block.
Connect the hydraulic valve (4) by this in a clockwise direction until it is closed permanently.
Note: The prisms blocks together and not individually use!
The prismatic blocks can be used from both sides

Manual Operation

14.1.1
Connect the hydraulic valve so that the pump works. Pump through the cylinder approaching the
workpiece. Pump handle with pipe directly onto the workpiece.
When WP 75H contact lever right side (19) for high pressure on the workpiece.

Pneumatic Operation

14.1.2
Place the work piece in a secure safe position on the V-prism edition.
Close hydraulic valve. Connect the pneumatic foot control with compressed air hose at the air
port. Press the foot control and the press cylinder now burdened the
If the press cylinder on the workpiece, you can press down upon prior removal of compressed air
to the handle tube slowly and carefully to the workpiece. By turning the hydraulic valve counter-
clockwise in small increments, you relieve the pressure
After the cylinder has fully retracted, remove the workpiece
Note: Disconnect the compressed air supply from the air.
NOTE: Lower the front of the press dismantling the entire table support all the way down
HOLZMANN Maschinen Austria
!
www.holzmann-maschinen.at
A T T E N T I O N
cylinder.
Werkstattpresse / shop press / Prensa para oficina WP 50H - WP 75H - WP 100
OPERATION
workpiece.
Seite 40