Power Failure; Once The Program Has Finished; The Best Drying Results; Unloading The Dishwasher - ETNA VW942HN Gebrauchsanweisung

Power failure

If the dishwasher is turned off due to a power failure when a dishwashing program is running, the
program continues when power is restored. If the power is cut during drying, the program is interrupted.
If the door is open for more than 2 minutes during drying, the program is interrupted.

Once the program has finished

The end of the program is indicated by one short signal from the buzzer. The chapter Settings describes
how to change this function.
Moreover, the end of the program is indicated by the status light turning off.
Once the dishwasher door is opened and the program has finished "End" appears on the display.
The dishwasher switches off automatically after the program ends. Shut off the water tap after each
use.

The best drying results

Fully load the dishwasher.
Angle dishes with hollows, such as cups, so that the rinse water will run off. This is also important
for plastic items.
Top up with rinse aid or increase the rinse aid dosage setting.
Activate the Automatic door opening option.
Open the door a little once the program has finished.
Allow the dishes to cool before unloading the dishwasher.

Unloading the dishwasher

Hot porcelain is more fragile. Leave the dishes to cool in the dishwasher before unloading them.
Unload the lower basket first to avoid any water drops from the upper basket falling onto the dishes
in the lower basket.
17