en
You can optimise your drinking water
by using the enclosed BRITA MAXTRA
water filter cartridge.
Further information on the use of the
BRITA water filter cartridge and
the BRITA Memo can be found in the
enclosed BRITA brochure.
Dispensing water
Fig. +
1. Open the filling device on the water
container.
2. Pour fresh water up to the mark in the
water container.
Note
Fill the water container with water only.
3. Press the glass against the dispenser
pad.
Water filter
Carefully read the enclosed BRITA
brochure together with the instructions
for the BRITA MAXTRA filter cartridge!
They contain important, safety-relevant
information.
Replacement filter cartridges can be
purchased from customer service or
from a specialist outlet.
m
Warning
Do not use the appliance in places
where the water quality is risky or not
sufficiently known about without suitable
disinfection, before and after filtering.
34
Interior fittings
You can reposition the shelves inside
the appliance and the door shelves as
required:
To do this, pull out shelf, lift at the front
■
and take out. Fig. (
Raise the door shelf and remove.
■
Fig. )
Chiller compartment
Fig. !/6
The chiller compartment has lower
temperatures than the refrigerator
compartment. Even temperatures below
0 °C may occur.
Ideal for storing fish, meat and sausage.
Not suitable for lettuce and vegetables
and produce sensitive to cold.
Bottle shelf
Fig. %
Bottles can be stored securely on
the bottle shelf. The holder can be
adjusted.
Ice cube tray
Fig. '
1. Fill the ice cube tray ¾ full of drinking
water and place in the freezer
compartment.
2. If the ice tray is stuck to the freezer
compartment, loosen with a blunt
implement only (spoon-handle).
3. To loosen the ice cubes, twist the ice
tray slightly or hold briefly under
flowing water.