Gude Basic 8T/DTB Originalbetriebsanleitung Seite 32

ENGLISH
28
Failure removal
Failures
Engine does not start
Wrong engine rotation direction
Splitting knife is not moving
Splitter has no power
The green supply button does not
hold after being pressed
Hydraulic pump is whistling, split-
ting knife running jerkily
Causes
No power in the socket
Defective electric extension cable
Wrong connecting cable
Defective condenser switch
Wrong connection
Adjust the two-hand control and
starting levers
Wrong rotation direction
Few hydraulic oil
Trigger is bent; hydraulic piston on
the valve is not fully seated
Wood has many knobs and the
splitting knife is getting stuck
Control arm is bent
Defective fuse, etc.
2-phase running
Oil loss, bottom contamination
<<Zu wenig Hydrauliköl>>
Removal
Check the fuse
Pull the plug out, check it, replace it
5-wire connection at 2.5 mm2 cross
section
Have the machine checked by a
professional electrician
Use a screwdriver to turn the phase-
changing switch in the power supply
Defective control valve - to be
replaced in a service centre only
Have the rotation direction changed
by a professional
Hydraulic oil to be added
Check all screws on the trigger
Adjust the trigger so that the
hydraulic piston on the valve is fully
seated
Lubricate the splitting knife
Put the control arm back to the
starting position
Check the cable
Tighten the screws replace the hose
<<Hydrauliköl nachfüllen>>