Connecting The Outlet Hose - Haier 7703422621 Bedienungsanleitung

CONNECTING THE OUTLET HOSE

The outlet hose should disharge into a
•
standpipe, making sure that there are no kinks
(fig. 6).
The standpipe must be at least 40 cm above
•
floor level and it must have an internal
diameter of at least 4 cm.
It is advisable to fit an anti-odour air trap
•
(fig. 6X). If necessary the outlet hose can be
extended up to 2,5 m, provided that it is kept
at a maximum height of 85 cm above floor
level. The extension pipe is available from the
After Sales Service Centre.
6
The hose can be hooked over the side of the
•
sink, but it must not be immersed in water, in
order to prevent water from being syphoned
back to the machine when this is in operation
(fig. 6Y).
When installing the appliance under a worktop
•
the hose pipe clamp must be attached to the
wall in the highest possible position under the
worktop (fig. 6Z).
Check that there are no kinks in the inlet and
•
outlet hoses.
EN 88