Ways Of Releasing Air Outdoors - Bosch B1 RKM 08000 Gebrauchsanweisung

Ways of releasing
air outdoors
Temporary installation
Permanent installation
22
Connect the diffusion duct to the hot-air
expulsion duct.
Open the window slightly and feed the diffusion
duct through the gap.
Close the window as much as possible and
secure it in place using the suction pad provided.
The appliance can be installed on a permanent
basis using window/wall Optional Accessory,
reference B1 RKZ 06009, available from your
supplier.
A hole must be made in the wall and the wall
accessory fitted in order to expel hot air.
Store the diffusion duct away and connect the air
expulsion duct to the accessory.
Only the transparent end section of the
accessory is used when air is to be expelled
through a window on a permanent basis. A 10.5-
cm. diameter hole must be made in the glass in
order to fit the accessory.
N.B.
• Do not extend the hot-air expulsion duct more
than necessary (maximum length: 140 cm.).
• There must be a distance of at least 70 cm.
between the floor and the end of the duct.
• Do not bend the duct too sharply when positioning
it.
This can impede proper hot-air expulsion, which
may reduce cooling efficiency.