Assembly Material; Installation Tools; Items Supplied - EINHELL 43.012.80 Bedienungsanleitung

Anleitung_RT_TC_560_U_SPK1:_
GB
Important!
When using the equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating instructions and
safety regulations with due care. Keep this manual in
a safe place, so that the information is available at all
times. If you give the equipment to any other person,
hand over these operating instructions and safety
regulations as well. We cannot accept any liability for
damage or accidents which arise due to a failure to
follow these instructions and the safety instructions.
Caution:
Laser radiation.
Do not look into the beam!
Laser class 2
Protect yourself and your environment from
accidents by taking the appropriate precautionary
measures.
Do not look directly into the laser beam with the
naked eye.
Never look directly into the laser path.
Never direct the laser beam at reflecting
surfaces, persons or animals. Even a low output
laser beam can inflict injury on the eye.
Caution: It is vital to follow the work procedures
described in these instructions. Using the tool in
any other way may result in hazardous exposure
to laser radiation.
Never open laser module.
When the tool is not going to be used for an
extended period of time, the batteries should be
removed.
12
30.12.2008 8:53 Uhr Seite 12
1. Layout (Fig. 1-2)
1. Feet
2. Diamond wheel
3. Trough
4. Work table
5. Angle stop
6. Rail fence
7. Chain bar
8. Safety hood for the cutting wheel
9. Handle
10. Star grip screw for setting the angle
11. Star grip screw for securing during transportation
12. Base frame
13. Cooling water pump
14. Hose
15. Motor
16. ON/OFF switch

1.2 Assembly material

17. Screw
18. Spring ring
19. Washer
20. Screw
21. Trough fixture
22. Star nut
23. Sealing plug
24. Holder

1.3 Installation tools

25. Wrench
26. Wrench

2. Items supplied

Tile cutting machine
Trough (3)
Cooling water pump (13)
Angle stop (5)
4 x foot (1)
Base frame
Assembly material (see 1.2)
Assembly tools (see 1.3.)