Charcoal Filters - FALMEC Fasteel Altair Top Isola 60 Inox Bedienungsanleitung

Inhaltsverzeichnis

Verfügbare Sprachen

Pushbutton +

Press to increase motor speed

Speed 1, 2 and 3 are indicated by the number of LEDs that light up (excluding the light and

the timer LEDs).

(In the 4-speed version the pushbutton + blinks. The fourth speed remains on for a set

duration of time. After 7 minutes the motor returns to the third speed).

Mode pushbutton

Function: it turns hood motor on and off.

The function "desired speed" enables to start the motor at the speed that was selected

before the hood was last turned off.

Optional: version with remote control (some versions only).

WARNING:

Install the hood away from sources of electromagnetic waves, as these could affect the

correct operation of the electronic system.

Maximum operating distance: 5 metres. The maximum operating distance could be less

than 5 metres in case of electromagnetic interference by other equipment.

Light pushbutton on remote control: light on/off.

– and + pushbutton: increase/decrease speed (to start the motor press either the + or the

– pushbutton).

Timer pushbutton: see instructions below.

Timer and 'filter clogged' alarm pushbutton

• This function allows the automatic turning off of the hood after running for 15 minutes at

the speed previously set (the pushbutton shows a flickering light).

• After about 30 hours of running the pushbutton indicates the need for washing the metal

filters (the pushbutton shows a solid red light). To disable the alarm press the pushbutton

for a few seconds until the red light turns off. Then turn the hood off and on again to check

that the alarm has disappeared.

FILTERS

1. METAL FILTERS

To access the metal filters, open the perimetral exhaust panel as described in Fig. H and

then act on handle A.

2. CHARCOAL FILTERS

To replace the charcoal filters, proceed as follows: remove the metal filters as described

above. The two filters located at the ends of the motor can now be easily accessed.

To install the new ﬁ lters see picture.

REMOVING AND REPLACING'S INSTRUCTIONS

Inhaltsverzeichnis