Preparing Coffee Drinks Via Direct Access; Preparing Milky Drinks Via Direct Access - Krups FULLY AUTOMATIC EA8918 Bedienungsanleitung

KR_FULLY-AUTO_EA89_CONNECTEE_8080016824.qxp_Mise en page 1 16/05/2017 10:01 Page25
DARK function
The "DARK" function allows you to increase the intensity of the coffee (its strength).
You can activate or deactivate it in various ways:
- Before selecting the chosen drink just press DARK.
- While preparing the drink, and until the end of grinding: you can press DARK.
- By choosing the "DARK" parameter in the Settings menu. To do this, access the Settings menu with the button
then Settings drink settings
You can do the same to deactivate it.
EXTRA SHOT function
The "extra shot" function allows you to add an espresso at the end of the selected drink.
You can activate or deactivate it in various ways:
- Before selecting the chosen drink: just press EXTRA SHOT.
- While making the drink,
- By choosing the "EXTRA SHOT" parameter in the Settings menu. To do this, access the Settings menu with the button
, then Settings
, , , .
You can do the same to deactivate it.

PREPARING COFFEE DRINKS VIA DIRECT ACCESS

N.b.: Every time the drink is launched, the machine will remember the last drink prepared, including the settings that
were selected.
Preparation
Place the cup(s) under the coffee nozzles. Fig.12
Press the button for the desired drink.
If the machine detects a lack of water when you request this preparation, it will ask you to fill the tank.
Possible settings
It is possible to increase the strength of the coffee by pressing
You can prepare one or two cups with your appliance.
The machine starts by grinding the beans, tamping the ground coffee and finally brewing the coffee. It is possible to
adjust the volume of the coffee being prepared by using the buttons:
You can stop the preparation at any time by pressing
!
Important: Automatic rinsing of the coffee outlets: according to the type of preparation, the machine may
complete an automatic rinse program when it switches off. The cycle lasts only a few seconds
and stops automatically.

PREPARING MILKy DRINKS VIA DIRECT ACCESS

Possible settings
It is possible to increase the strength of the coffee by pressing
The steam is used to froth the milk. As a higher temperature is required when producing steam, the appliance will run
an additional pre-heating phase.
Making a Cappuccino
Connect the straight side of the milk tube to the "One Touch Cappuccino" block Fig. 13.
Immerse the other end (bevelled side) in a receptacle filled with milk or directly in your bottle of milk Fig. 14.
Place the cup(s) under the coffee/milk nozzles. Fig.15.
Press the "Cappuccino" button
The preparation starts by frothing the milk (possible to set the time), and then the coffee flow (possible to adjust the
volume). Adjusting the frothing time allows you to vary the quantity of milk and froth.
The next steps follow automatically and your drink is ready to taste Fig.17.
Every time "Cappuccino" is run, the machine will remember the last drink prepared, including the settings that were
selected.
Dark. The function will be activated for all "coffee" drinks:
drink settings EXTRA SHOT. Therefore, the function will be activated for all preparations
Fig. 16. All of the settings can be modified.
and/or adding a coffee preparation by pressing
and .
.
and/or adding a coffee preparation by pressing
,
, , , .
,
.
.
25