MSI Z270 GAMING M7 Kurzanleitung Seite 55

fThreshold 1~3 (A) [Auto]
Sets the CPU current as the threshold for Dynamic Frequency Control. When
CPU current reaches the value, it will run the Level 1/ 2/ 3 BCLK for dynamic
overclocking. These items will appear when the Dynamic Frequency Control is
enabled.
fLevel 1~3 BCLK (MHz) [Auto]
Sets the CPU BCLK for the threshold. These items will appear when the Dynamic
Frequency Control is enabled.
fDynamic Frequency Search [Disabled]
Enables or disables to run the optimized dynamic BCLK. This item will be disabled
when the Dynamic Frequency Control is enabled.
fDynamic Frequency Search Mode [Once]
Sets the search mode of the dynamic BCLK. This item will be available when the
Dynamic Frequency Search is enabled.
[Once]
[Each Power On] Run in every time when system is powered on.
fDynamic Frequency Search Step (MHz) [Auto]
Sets the increase for running the dynamic BCLK. If set to Auto, BIOS will configure
this setting automatically. This item will be available when the Dynamic Frequency
Search is enabled.
fBCLK Amplitude [Auto]
Sets the value for BCLK Amplitude for overclocking. Higher value might benefit to
get higher overclocking values.
fBCLK Slew Rate [Auto]
Sets the value for BCLK Slew Rate for overclocking. The value might vary
depending on the actual overclocking scenario.
fBCLK ORT Duration [Auto]
Sets the value for BCLK ORT duration for overclocking. The value might vary
depending on the actual overclocking scenario.
Extreme Memory Profile (X.M.P.) [Disabled]
f
X.M.P. (Extreme Memory Profile) is the overclocking technology by memory module.
Please enable XMP or select a profile of memory module for overclocking the memory.
This item will be available when the memory modules that support X.M.P. is installed.
DRAM Reference Clock [Auto]*
f
Sets the DRAM reference clock. The valid value range depends on the installed CPU.
This item appears when a CPU that supports this adjustment is installed.
DRAM Frequency [Auto]
f
Sets the DRAM frequency. Please note the overclocking behavior is not guaranteed.
Adjusted DRAM Frequency
f
Shows the adjusted DRAM frequency. Read-only.
Run once in the next system boot.
45
BIOS Setup