Russell Hobbs 27290-56 Bedienungsanleitung Seite 5

CRISPING TRAYS
Fit the crisping trays into the bottom of each basket before fitting the basket dividers or joining the
baskets together. Insert the front edge of the crisping tray under the curved projections that are along the
inside edge of the basket as shown (Fig. 1). Press the back edge down to seat the crisping tray into the
basket. Make sure that the trays are fitted correctly so that they don't fall out if the basket is tipped.
ASSEMBLING THE BASKETS
To use one large basket
1. Remove the baskets from the body.
2. If present, slide the basket dividers out of each basket.
3. If they are not already fitted, fit a crisping plate into each basket.
4. Place the baskets side by side so that they are touching and aligned with each other (A).
5. Align the U-channel connector with the grooves on both sides of the baskets simultaneously and
slide it partway into the basket (B).
6. Apply gentle outward pressure with your thumbs onto the top of the connector (C). Slide the
connector downwards while maintaing the outward pressure. This will keep the connector aligned
with the grooves on the inside of the basket.
7. Continue until the connector clicks into place.
8. If the connector binds up or jams when it is near to its final position, use your fingers to gently pull
the bottoms of the baskets against your body (D). This will help to keep them aligned.
• Don't force anything. It should only require gentle/moderate pressure to install the basket
connector,. Forcing it to fit might cause damage. If it doesn't fit correctly, remove it and then check
that the baskets are still in contact and aligned with each other, then try again.
To use two separate baskets
1. Remove the baskets from the body.
2. If present, remove the basket connector (E).
3. Separate the baskets (F).
4. Insert the crisping plates if you are using them.
5. Orient each basket divider so that:
• the arrow on the divider is pointing downwards.
• The folded-over part on the top edge of each divider is facing outwards (see figures G and H).
6. Slide the divider into the basket slot.
7. Repeat for the other basket.
Note: If you don't orient the basket dividers correctly (step 5) before fitting, they will fall out when the
baskets are inverted.
Scan this QR code for a video showing how to assemble the baskets.
5
GB
DE
FR
NL
IT
ES
PT
DK
SE
NO
FI
RU
CZ
SK
PL
HR
SI
GR
HU
TR
RO
BG
UA
AE