Inventum AKI6005ZWA Gebrauchsanleitung Seite 16

INSTALLATION
• This appliance should only be connected by a registered
installer.
• Always follow the installation instructions in the installation
manual (chapter 7) provided.
• Check the appliance for transport damage. Do not connect a
damaged appliance.
• Faulty parts may only be replaced by original parts. The
manufacturer can only guarantee that original parts meet safety
requirements.
• If the connecting cable is damaged, it may only be replaced
by the manufacturer, the manufacturer's service organisation
or equivalently qualified persons, in order to avoid dangerous
situations.
• Always use the original cable and plug to connect the appliance.
• The electrical connection must comply with national and local
regulations.
• The wall plug socket and plug should always be accessible.
• If you want to make a fixed connection, make sure that an
omnipolar switch with a contact separation of at least 3 mm is
fitted in the supply cable.
• The appliance should not be connected to the mains via a
multi-plug adapter or extension cable, as the safe use of the
equipment cannot be guaranteed.
• Warning: Never open the appliance casing. The casing may
only be opened by a service technician.
• Disconnect the appliance from the mains supply before starting
any repair work.
• We advise wearing protective gloves when assembling the
cooker hood because of the possible sharp edges.
• The distance between the lowest point of the cooker hood and
the supported surface for the cooking pans gas hob should be
at least 75 cm. With an electric, ceramic or induction hob this
distance should at least be 65 cm.
• If the instructions of the gas hob specify a greater distance, this
should be taken into account.
• Warning: failure to install screws or fixing devices in
accordance with these instructions may result in electrical
hazard.
16
• English