Herunterladen Inhalt Inhalt Diese Seite drucken

Adler europe AD 2013 Bedienungsanweisung Seite 4

Vorschau ausblenden Andere Handbücher für AD 2013:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 5
immediately remove the power plug or power adaptor from the socket. If the device is
powered, do not put hands in the water. Have the device checked by the qualified
electrician before using it again.
18. Do not touch the device or power adaptor with wet hands.
19. The device has to be turned off after every use.
20.
Do not leave the unit on to the wall outlet or power supply unit unattended.
21. If the device utilises a power adaptor, do not cover it, because this can cause a
dangerous temperature rise and can damage the device. Always connect the power
adaptor cable to the device, and then connect the power adaptor to the power socket.
22. Keep the device out of the reach of children. Using the devices by children must be
supervised by adults.
23. The power cord should not touch hot parts of the device and should not be located near
other heat sources.
24. Do not wrap electric cable around the device.
25. Do not use a hair curling iron in the bath.
26. Do not remove dust or foreign bodies from the inside of the hair straightener using
sharp objects.
27. Do not use outdoors or where aerosols are being used or where oxygen is being
administered.
28. Do not cover the hair curling iron, it might cause the accumulation of heat in its interior
and it may cause damage or fire.
29. Hairsprays contain flammable materials. Do not apply them while using the device.
30. Do not use the device on people who are sleeping.
31. The device can be supplied only with the voltage specified on the housing.
32. During operation, do not place the device on wet surfaces or clothes.
33. After use, turn off and unplug the unit. Wait until the device cools down before storing.
34.During the operation ceramic plates heat up to high temperatures. Do not touch hot
parts of the hair curling iron and do not allow contact with the skin of the head, because it
may cause burns
35. The device is not designed to work with external schedulers or separate remote control
system.
PRODUCT DESCRIPTION (pic. 1)
1 - housing
3 - switch On/Off/temperature adjustment
5 - swivel cord
USING THE DEVICE
1. Attach brush (2) - type as required
2. Plug into socket.
3. Turn on hair styler with switch (3). Adjust required air temperature (1 - cool shot, 2 - lower temperature and speed, 3 - higher
temperature)
4. Separate streak of hair, brush out, and start to wind from the end on the brush. Wait few seconds till hot air stream consolidate shape
of winded hairs.
5. Unwind hairs.
6. Turn off hair styler and form required hairstyle with brush or comb.
7. Unplug from the socket.
CLEANING AND MAINTENANCE
1. Unplug Hair Styler before start cleanning.
2. Wipe outer housing (1) with damp cloth. Do not use abrasive or sharp materials.
3. Clean brush from hairs after each use.
4. Check if the air inlet cover is not stuck with hairs or other dirt. If necessary clean this out.
5. Do not leave any hairs on the hair styler.
6. Do not wind cord around the appliance.
TECHNICAL DATA
2 - removalbe brushes
4 - brush lock button
4

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis