Jci1: Chassis Intrusion Connector; T_Sen1: Thermal Sensor Connectors - MSI MPG B550 GAMING CARBON WIFI Kurzanleitung

JCI1: Chassis Intrusion Connector

This connector allows you to connect the chassis intrusion switch cable.
BAT1
Using chassis intrusion detector
1. Connect the JCI1 connector to the chassis intrusion switch/ sensor on the chassis.
2. Close the chassis cover.
3. Go to BIOS > SETTINGS > Security > Chassis Intrusion Configuration.
4. Set Chassis Intrusion to Enabled.
5. Press F10 to save and exit and then press the Enter key to select Yes.
6. Once the chassis cover is opened again, a warning message will be displayed on
screen when the computer is turned on.
Resetting the chassis intrusion warning
1. Go to BIOS > SETTINGS > Security > Chassis Intrusion Configuration.
2. Set Chassis Intrusion to Reset.
3. Press F10 to save and exit and then press the Enter key to select Yes.

T_SEN1: Thermal Sensor Connectors

This connector allows you to connect the thermistor cable and use it to monitor the
temperature of the detection point.
BAT1
26
Overview of Components
Normal
(default)
Sense
GND
Trigger the chassis
intrusion event
Thermistor cable