Operation Instructions; Assembly & Operation - Worx WP280E Serie Originalbetriebsanleitung

5. OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction
book carefully.
WARNING! Do not use the product without
attaching the guard and front handle.
ASSEMBLY & OPERATION
ACTION
BEFORE USING YOUR CORDLESS
HEDGETRIMMER
Assembling the safety guard
Assembling the front handle
NOTE : The handle is designed to prevent
being assembled in wrong direction .
If you find it cannot be installed, please
turn it around.
Checking the battery charge condition
NOTE : Fig. C only applies for the battery
pack with battery indicator light.
Charging the battery pack
NOTE :
• The batteries are shipped
uncharged. Each battery must be
fully charged before the first use.
• Always fully charge the two batteries
at same time. More details can be
found in charger's manual.
Installing and Removing the battery pack
NOTE :
• This machine will only run when
2 batteries are installed. It is
recommended to use the same
two batteries and charge the
two batteries at the same time.
• When you use two batteries with
different power, the machine will
only run to the lower common
denominator.
OPERATION
Hedge trimmer
Power indicator light
See details in BATTERY STATUS part
IMPORTANT:
When only one light is illuminated,
your battery is overly discharged,
even though the trimmer may still
be capable of hedge trimming.
Continuing to operate your trimmer
with the battery in this discharged
condition may reduce the life and
performance of your battery.
FIGURE
When no light is illuminated, at least
one battery is not fully installed or
battery may be defective, please
double check the batteries are fully
See Fig. A seated into position.
Remove the blade sheath
See Fig.
Starting and stopping
B1, B2
Rotating rear handle
NOTE :
• Unlock the locking switch before
See Fig. C
rotating.
• After rotating the handle to the
desired position, adjust it a little until a
click can be heard.
WARNING:
See Fig. D
• Always make sure that the handle
is locked in the desired position
before operation.
• Always make sure the locking
switch is locked before starting
the hedge trimmer.
Top cutting
WARNING: If any parts are miss-
See Fig. E
ing, damaged or broken, do not
operate your hedge trimmer until all
damaged parts have been replaced or
repaired. Failure to do so could result
in serious personal injury. DO NOT USE
WITHOUT FRONT HANDLE AND SAFETY
GUARD.
Side cutting
WARNING: Stop operating the trimmer
before rotating the handle.
Lubricating the Cutting Blade
NOTE : It is important to use only the
recommended standard lubricating oil
(WD-40) to avoid damage to the blade.
To store your hedge trimmer
See Fig. F
See Fig. G
See Fig.
H1, H2
11
See Fig.
I1, I2
See Fig. J
See Fig.
K1, K2
See Fig. L
See Fig. M
EN