Accessories; Assembly And Operation - Worx Worxsaw XL WX427 Originalbetriebsanleitung

ACCESSORIES

TCT Blade: 24T for wood
(WA5046)
HSS Blade: 60T for thin sheet
steel and aluminum, PVC
pipe, plastic (WA5047)
Abrasive cutting Disc: 60G for
concrete, marble, tile, cement
backerboard (WA5048)
Multipurpose Blade: 18T for
wood, steel, wood with nails,
aluminum, plastic (WA8304)
Parallel Guide
Vacuum Adaptor
Hex Key
TCT Blade: 24T for wood
(WA5046)
HSS Blade: 60T for thin sheet
steel and aluminum, PVC
16
pipe, plastic (WA5047)
Abrasive cutting Disc: 60G for
concrete, marble, tile, cement
backerboard (WA5048)
Multipurpose Blade: 18T for
wood, steel, wood with nails,
aluminum, plastic (WA8304)
Parallel Guide
Vacuum Adaptor
Hex Key
We recommend that you purchase your accessories
listed in the above list from the same store that sold
you the tool. Refer to the accessory packaging for
further details. Store personnel can assist you and
offer advice.
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
INTENDED USE:
The tool is intended for ripping and cross-cutting wood
and other materials in straight cutting lines, while
resting firmly on the work piece.
Compact Circular Saw
WX427 WX427.2
1 1
1 1
1 1
/ 1
1 1
1 1
1 1
WX427.3
2
1
1
/
1
1
1

ASSEMBLY AND OPERATION

Action
Saw Blade Assembly And
Removing
Safety On/Off Switch
Note: Keep the dust adapter
connected to dust collecting
device when using the tool.
Cross And Rip Cutting
Using The Laser Light Feature
Replacing Laser Batteries
Parallel Guide
Cutting Depth Adjusting
Cutting Angle Adjusting
Pocket Cutting
Sawdust Removal
WORKING HINTS FOR YOUR
TOOL
If your power tool becomes too hot, please run your
circular saw no load for 2-3 minutes to cool the
motor. Avoid prolonged usage at very low speeds.
Protect saw blades against impact and shock. Cutting
with extreme force can significantly reduces the
performance capability of the tool and reduces the
service life of the saw blade. Sawing performance
and cutting quality depend essentially on the
condition and the tooth count of the saw blade.
Therefore, use only sharp saw blades that are suited
for the material being cut.
Choice of blades: 24 teeth for general work, approx.
40 teeth for finer cuts, more than 40 teeth for very
fine cuts into delicate surfaces, diamond for tile,
cement board, etc.
Only use saw blades recommended.
Figure
See Fig. A
See Fig. B
See Fig. C1, C2
See Fig. D1, D2
See Fig. E1-E3
See Fig. F1, F2
See Fig. G1, G2
See Fig. H
See Fig. I1, I2
See Fig. J
EN