Cruise Control; Error Code - FAFREES F26 CarbonX Bedienungsanleitung

DISPLAY CONTROL PAD
1. Display interface switching：When the display is powered on, it will show the Current Speed (km/h)
and Trip Odometer (km) by default. Short press mode button to switch between Real-time speed(km),
Average Speed (km/h), Trip Odometer(km), Maximum Speed (km/h), Single trip distance (Km/h), Single
trip time, and Real-time speed (Km/h).
2. Assist level: Use up/down button to switch the assist level. Power assist is triggered when you pedal
forward, and stops when you stop pedaling, sometime with a delay.
3. Walk Assist Mode: Long press the down button, the electric bicycle will enter the walk assist mode.
The electrical bike runs at a constant speed of 6 km/h. Release the down button, the electric bicycle will
immediately stop power output and return to the state before push.
TURN ON THE LIGHT
By pressing and holding the light button on the right-hand side, the controller will turn on/off the
headlight.
ELECTRIC MODE
You do not need to pedal the e-bike if you use the hand throttle. The throttle can be controlled by twisting
it from the resting position, and the farther the throttle switch is from resting position, the more power is
sent to the motor to accelerate the e-bike. The hand throttle can be removed if you don't need it or
due to local law restriction.

CRUISE CONTROL

Cruise control will be triggered when you holding thumb throttle and riding at the same speed for 8
seconds, and it will be released by braking/pedaling or throttling.

ERROR CODE

If there is a fault occurs in the electronic system of the electric bicycle, the display will automatically show
an error code, see below for a detailed definition of the error code.
Error code Definition
E21 Current failure
E22 Throttle failure
E23 Motor phase failure
EN
Error code Definition
E24 Hall failure
E25 Brake failure
E30 Communication failure
18