Charge And Discharge Programs; Program Fl Owchart - GRAUPNER ULTRA TRIO PLUS 16 Bedienungsanleitung

6. Charge and discharge programs (Output 1)
The various facilities of the charger are divided up into four program groups which you can select by holding
the PROG-MODE button pressed in for two seconds. The sequence is shown in the fl ow chart below.
Ni-Cd battery programs: charging, conditioning, discharging to determine capacity or residual capacity, or to
select cells.
Ni-MH battery programs: charging, conditioning, discharging to determine capacity or residual capacity, or
to select cells.
LiPo / LiIo / LiFe battery programs: charging, discharging to determine capacity or residual capacity, or to
select cells.
Lead-acid battery programs: charging, discharging to determine capacity or residual capacity, trickle charge
for stand-by operation.
NiCd
MODE
AUTOMATIC-
program
MODE
(2 sec.)
MODE (2 sec.)
NiMH
MODE
AUTOMATIC-
program
MODE
(2 sec.)
MODE (2 sec.)
Lithium
MODE
MANUAL-
program
MODE
MODE (2 sec.)
(2 sec.)
Pb
MODE
MANUAL-
program
MODE
MODE (2 sec.)
(2 sec.)
32
7. Program fl owchart (Output 1)
NiCd
MODE
MANUAL-
discharge
program program
NiMH
MODE
discharge
MANUAL-
program
Lithium
MODE
discharge
program
Pb
MODE
discharge
program
NiCd
NiCd
MODE
cycle
program
NiMH NiMH
MODE
cycle
program program
Lithium
MODE
Lithium
storage
program
NiCd
MODE
discharge balan-
cing program
NiCd
MODE

delta-peak
trigger voltage
NiMH
MODE
discharge balancing
program
MODE NiMH

delta-peak
trigger voltage
MODE
type
select
MODE
MODE