Rollei Mark IIs Anleitung Seite 41

Operation
4 . Set the same channel and group to your flash and to your transmitter
(part 2 and 5 in the function description) .
Note: The flash lights that are using the same channel can be adjusted
separately in different groups regarding their mode and power output .
5 . Press the test button to make sure that the flash lights will sync with the
transmitter .
6 . Press the group button to set the different modes (M/TTL) .
7 . Press the sync button to switch between the different sync modes: front
curtain sync, rear curtain sync and high speed sync .
To change the menu of function keys, briefly press the on/off key .
8 . Press the modeling lamp button to activate or deactivate the modeling
lamp of the flash .
9 . Press function key 2 to switch the flash signal tone on or off .
10 . Press function key 3 to display the output power of the flash in TTL mode in
Manual mode . However, this function only works when group A is used .
41