Cleaning The Tool - Makita DUR193 Betriebsanleitung

MAINTENANCE
WARNING:
Always be sure that the tool is
switched off and battery cartridge is removed
before attempting to perform inspection or main-
tenance on the tool. Failure to switch off and remove
the battery cartridge may result in serious personal
injury from accidental start-up.
NOTICE:
Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
To maintain product SAFETY and RELIABILITY,
repairs, any other maintenance or adjustment should
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
Replacing the nylon cord
WARNING:
Use nylon cord with diameter specified in "SPECIFICATIONS" only. Never use heavier line,
metal wire, rope or the like. Use recommended nylon cord only, otherwise it may cause damage to the tool and
result in serious personal injury.
WARNING:
Make sure that the cover of the nylon cutting head is secured to the housing properly as
described below. Failure to properly secure the cover may cause the nylon cutting head to fly apart resulting in
serious personal injury.
CAUTION:
When installing or removing the nylon cord, be careful not to contact the nylon cord cutter
on the protector. Contact with the cutter may result in personal injury.
Replace the nylon cord if the cord is not feeding any more.
► Fig.30: (1) Up to 8 m (2) 70 - 80 mm

Cleaning the tool

Clean the tool by wiping off dust, dirt, or cut off grass
with a dry cloth or one dipped in soapy water and wrung
out. If the cut off grass is adhered to the motor housing,
be sure to remove it.
► Fig.27: 1. Motor housing
Storage
When storing the tool, raise the wire guard, shorten the
shaft, and then fold the loop handle.
► Fig.28: 1. Wire guard
► Fig.29: 1. Loop handle 2. Shaft
16 ENGLISH