Installing The Batteries In The Remote Control - afx light CLUB-UV450 Bedienungsanleitung

IR REMOTE CONTROLLER
Please operate the remote control within a distance of 6m and 30° between the remote and the
appliance. Aim the remote at the sensor. Remove all obstacles between the remote and the sensor.
The remote control might not work properly if the sensor is exposed to strong sunshine.
If the remote control doesn't work properly, please check the batteries.

INSTALLING THE BATTERIES IN THE REMOTE CONTROL

• Place the remote face down on a flat surface.
• Push the compartment cover into the direction of the arrow.
• Slide the battery compartment open.
• Remove the old battery and install the new one (CR2025) with the plus (+) sym-
bol facing up.
• Gently slide the battery compartment closed. It locks automatically.
RECOMMENDATIONS FOR BATTERIES
This symbol indicates that used batteries should not be disposed of with household waste but deposed correctly in accordance with
your local regulations..
Batteries shall not be exposed to excessive heat such as sunshine, fire or the like.
When the internal batteries are not to be used, remove them to avoid damage caused by battery leakage or corrosion.
ATTENTION: Danger of explosion if battery is incorrectly placed. Only replace by the same or equivalent type.
WARNING :Do not swallow the battery. Danger of chemical burns. Keep new and old batteries out of the reach of children.
If the battery compartment doesn't close properly, stop using the product and keep it out of the reach of children.
If you are in doubt whether the batteries have been swallowed or introduced into any other part of the body, contact immediately a doctor.
REMOTE CONTROL
NOTE: PLEASE SET THE UNIT TO MODE -> ADDR, OTHERWISE
THE REMOTE CONTROL WILL NOT WORK
1. BRIGHTNESS & SPEED adjustment: Press
brightness and speed in programme mode
2. ON/OFF of the LEDs.
SELECT LED:
R: LED 1
G: LED 2
B: LED 3
W: LED 4
3. COLOUR BUTTONS: Press one of the 12 colour buttons to select a
built-in programme.
PHOTOMETRIC DIAGRAM
FIXTURE CLEANING
The cleaning of internal and external optical lenses and/or mirrors must be carried out periodically
to optimize light output. Cleaning frequency depends on the environment in which the fixture
operates: damp, smoky or particularly dirty surrounding can cause greater accumulation of dirt
EN 6
or to set the
© Copyright LOTRONIC 2023