Service Programmes - Siemens TI 303 Gebrauchsanleitung

en Service programmes
.

Service programmes

Every so often – with the exact
S e r v i c e p r o g r a m m e s
frequency depending on water
hardness and usage – the calc'nClean
button will light up. The display shows
"Calc'nClean required".
The appliance should be immediately
cleaned and descaled using the
programme.
Notes
Important: If the appliance is not
■
cleaned and descaled in good time,
it may be damaged.
Important: If the appliance is not
descaled and cleaned in good time,
it will be locked.The display shows
"Device locked"
If the appliance is locked, it can only
be operated again once the service
programme has been carried out.
Caution! For each of the service
■
programmes, use Calc'nClean
descaling and cleaning agents as
described in the instructions and
observe the (relevant) safety
information.
Do not drink the liquids.
■
Never use vinegar, vinegar-based
■
products, citric acid or citric
acid-based products for descaling.
For cleaning and descaling only use
■
the tablets intended for such
purpose.They have been specially
developed for this appliance, and
new stocks can be ordered through
customer service. ~ "Accessories"
on page 34
Never insert descaling tablets or
■
other products into the brewing unit.
Never interrupt the service
■
programme.
Prior to starting a service
■
programme, remove, clean and
re-insert the brewing unit. Clean the
milk frother.
46
At the end of a service programme,
■
wipe down the appliance using a
soft, damp cloth to immediately
remove any descaler residue. This
residue may cause corrosion.
New sponge cloths may contain
■
salts. Salts can cause rust film on
stainless steel, so cloths must
always be washed out thoroughly
before use.
If one of the service programmes is
■
interrupted, e.g. by a power failure,
proceed as described in the section
Calc'nClean from item 10.