Hansa BHI68320 Bedienungsanleitung Seite 33

INSTALLATION
Connecting to electrical mains
Electrical connection must be made by
a properly certified and qualified instal-
ler. Before connecting the appliance,
check the following:
1. Wiring connection diagram located on
the power cord
2. Rated voltage on the rating plate
3. Is the power cord suitable for connec-
ting the appliance
Do not use switches, extension cords,
etc., to connect the appliance, as these
can cause a fire. The power cord must
not come into contact with hot surfaces
and sharp edges of the appliance. Any
modifications of the existing electrical
wiring in the building must be performed
only by a qualified electrician. Connec-
tion diagram is shown below:
Connecting to electrical mains
Electrical connection must be made by a properly certified and qualified installer. Before
connecting the appliance, check the following:
1. Wiring connection diagram located on the power cord
2. Rated voltage on the rating plate
3. Is the power cord suitable for connecting the appliance
Do not use switches, extension cords, etc., to connect the appliance, as these can
cause a fire. The power cord must not come into contact with hot surfaces and sharp
edges of the appliance. Any modifications of the existing electrical wiring in the building
must be performed only by a qualified electrician. Connection diagram is shown below:
1N
2N
33
220-240V~
25A
220-240V~
380-415V~
16A
220-240V~
16A