Environmental Concerns - Zanussi ZBB8294 Benutzerinformation

ca. 50 mm
90°
21 mm
90°
ca. 50 mm
21 mm
Install the part (Ha) on the
inner side of the kitchen
furniture.
Hb
Place the small square on
the guide again and fix it
with the screws supplied.
Align the kitchen furniture
door and the appliance
door by adjusting the part
Hb.
Do a final check to make sure that:
• All screws are tightened.
• The magnetic sealing strip is attached tightly to the
cabinet.

Environmental concerns

The symbol on the product or on its packaging
indicates that this product may not be treated as
household waste. Instead it should be taken to the
appropriate collection point for the recycling of electrical
and electronic equipment. By ensuring this product is
disposed of correctly, you will help prevent potential
Downloaded from Fridge-Manual.com Manuals
All manuals and user guides at all-guides.com
Ha
Hc
Push the part (Hc) on the
part (Ha).
Hb
Hd
Press the part (Hd) on the
part (Hb).
8 mm
Ha
Hb
Open the appliance door
and the kitchen furniture
door at an angle of 90°.
Insert the small square (Hb)
into guide (Ha).
Put together the appliance
door and the furniture door
and mark the holes.
Important! If the ambient temperature is low (for example,
in the Winter), the size of the gasket decreases. The size of
the gasket increases when the ambient temperature
increases.
negative consequences for the environment and human
health, which could otherwise be caused by inappropriate
waste handling of this product. For more detailed
information about recycling of this product, please contact
your local council, your household waste disposal service
or the shop where you purchased the product.
8 mm
K
Ha
Remove the brackets and
mark a distance of 8 mm
from the outer edge of the
door where the nail must be
fitted (K).
25