Problem Solving Guide; Technical Data; Conformity Declaration - Miele Complete C3 Gebrauchsanweisung

en

Problem solving guide

Many malfunctions and faults that can occur in daily operation can be easily
remedied. Time and money will be saved because a service call will not be
needed.
The following guide may help you to find the reason for a malfunction or a fault,
and to correct it.
Problem
The vacuum cleaner
switches off automatic-
ally.
On certain models, the
overheating warning
light also comes on .

Technical data

(for models with radio controlled handle)
Frequency band
Maximum transmitting power

Conformity declaration

Miele hereby declares that this vacuum cleaner complies with Directive 2014/53/
EU.
The complete text of the EU declaration of conformity is available from one of the
following internet addresses:
– Products, Download from www.miele.co.uk
– For service, information, operating instructions etc: go to www.miele.co.uk/do-
mestic/customer-information-385.htm and enter the name of the product or the
serial number
60
Cause and remedy
A temperature limiter switches the vacuum cleaner off
automatically if it gets too hot. This can occur if, for
instance, large articles block the suction tube or when
the dustbag is full or contains particles of fine dust. A
heavily soiled exhaust or dust compartment filter can
also be the cause of overheating.
 Switch the vacuum cleaner off immediately using
the On/Off foot control . Disconnect from the
electricity supply. Switch off at the wall socket and
unplug it.
After removing the cause, wait for approximately 20 -
30 minutes to allow the vacuum cleaner to cool down.
It can then be switched on again.
433.05 MHz – 434.79 MHz
< 10 µW