Operation; Menu Structure - EuroLite LED PLL-576 Bedienungsanleitung

OPERATION

After connecting the device to the mains it is ready for operation. The display indicates the last operating
mode. The operating modes can be selected by means of the display and the control buttons and the wheel
encoders. The device can be operated in stand-alone mode via the control board or in DMX-controlled mode
via any commercial DMX controller as well as wireless via QuickDMX with the optional available EUROLITE
QuickDMX USB Wireless Transmitter/Receiver.

Menu structure

The Control Board offers several features: you can easily set the starting address or select a DMX channel
mode.
The main menu is accessed by pressing Menu. Browse through the menu by pressing Up or Down. Press
Enter in order to select the desired menu. You can change the selection by pressing Up or Down. Press
Enter in order to confirm. You can leave every mode by pressing Menu. The functions provided are listed as
follows.
If you press and hold Up or Down, the values change faster. The device has an automatic storage for all
settings. When you switch the device off and on again, it will operate with the previously set values.
If the device is not operated for 30 seconds, the buttons will lock. Unlock them by pressing any button for
about three seconds.
The device is additionally equipped with two wheel encoders. The use of these wheel encoders is possible
as long as there is no DMX signal at the DMX input.
Default settings in bold
MAIN level Menu level
Def.Set ON/OFF
DMX Addr 001-512
2.1 CH
2.2 CH
DMX Chan 3.1 CH,
3.2 CH,
4 CH
Master/Slave Master/Slave
Strobe 0-100
Blackout
DMX Fail
Hold
All on
Temp
Wheel Encoders
Briefly press the desired wheel encoder and set brightness or a preset color temperature. Turn the wheels
to the left and right to change the selection. To save the setting, confirm each change by pressing the
wheel encoder, for at least one second. The display confirms the saving with OK.
Dimmer 0-100
SW Macro 1-69
Description
Reset to factory settings
DMX address setting
Setting DMX channel mode
Master/Slave mode
0 - no function
1-100 - strobe effect with increasing speed
Behavior in case of missing DMX signal
Blackout – LEDs go off
Hold – holds the last received signal
All on- all LEDs 100% on
Displays the inside temperature of the device in °C
Dimmer intensity 000 – 100 (increasing)
69 preset color temperatures
26/32 00146376, Version 1.0