Machine Start And Stop; Stopping The Machine - Nilfisk BA 410 Betriebsanleitung

ENGLISH

MACHINE START AND STOP

Starting the machine
1. Prepare the machine as shown in the previous paragraph.
2. Lower the squeegee (11) with the lever (19).
3. Turn the solution fl ow control lever (4) to one of the following positions, according to the type of cleaning to be performed:
• ECO system: when the lever (4) is turned to ECO position (5), the machine works in a special condition of programmed
water "economy" usage; as the water fl ow is set and constant, the machine can work with a washing autonomy of 70-80
minutes (0.3 litres/min average).
• Variable system: when the lever is turned to the left (variable fl ow) the fl ow rate can increase up to 1 litres/min.
• In no case it is possible to close completely the water fl ow to the brushes during operation.
4. While keeping the hand on the handlebar (2), start the machine by turning the brush/pad-holder switch and the vacuum system
switch (65 and 66) to "I".
NOTE
If the green warning light (62) turns on, the batteries are ready to be used. If the yellow or red warning light (63 or 64)
turns on, the batteries must be charged (see the procedure in Maintenance chapter).

Stopping the machine

5. Turn the brush/pad-holder switch and the vacuum system switch (65 and 66) to "0".
6. Lift the squeegee with the lever (19).
7. Insert the positioning pin (24) and lift the brush/pad-holder by engaging the transport/parking device (23a).
14
USER MANUAL
909 5683 000(4)2009-11 A BA 410