Setting Into Operation - IMG STAGELINE PAR-36W Bedienungsanleitung

3) Screw off the screw cover (5), remove the holding
ring (4), and take the old lamp carefully out of the
housing (see fig. 1). Loosen the two screws at the
lamp base, and pull off the connection cable.
4) Install the new lamp: slightly loosen the two screws
at the lamp socket, tightly clamp one cable lug each
of the connection cable below each screw, and
tighten the screws again. Carefully place the lamp
into the spotlight housing and clamp it with the hold-
ing ring (4).
5) Screw on the screw cover (5) again.

4 Setting into Operation

1) Remove the protective foil from the colour filter disc
(6), and attach the colour filter disc to the spotlight
housing (see fig. 2).
2) Fix the unit via the mounting bracket (3) with a sup-
port for light radiating units or a stable mounting
screw to the desired place, e. g. to a traverse for
light radiating units or a stand.
WARNING The unit must be mounted in a safe
and expert way. If it is installed as a
suspend ed load above persons, it
must additionally be secured (e. g.
by a safety rope at the mounting
bracket; fix the safety rope in such a
way that the maximum falling dis-
tance of the unit is 20 cm).
3) For aligning the unit loosen the two knob screws (2)
at the mounting bracket, adjust the desired inclina-
tion of the unit, and tighten the knob screws again.
4) Connect the plug of the mains cable (1) to a mains
socket (230 V~ / 50 Hz). With connection to the
power supply the spotlight is switched on: the lamp
lights and the colour filter disc rotates.
5 Specifications
Voltage supply: . . . . . . . . 230 V~ / 50 Hz / 45 W
Rotating speed: . . . . . . . 1 – 2 rpm
Lamp insert: . . . . . . . . . . PAR 36 lamp (6 V/ 30 W;
Dimensions: . . . . . . . . . . 245 × 315 × 170 mm
Weight. . . . . . . . . . . . . . . 1.2 kg
Subject to technical modification.
All rights reserved by MONACOR
be reproduced in any form or by any means for any commercial use.
All manuals and user guides at all-guides.com
socket: 2 × screw)
INTERNATIONAL GmbH & Co. KG. No part of this instruction manual may
®
GB
7