Sirius SM903 SL Technische Informationen Seite 16

MAINTENANCE
An accurate maintenance guarantees good
functioning and long-lasting performance.
Particular care is due to the grease filter pa-
nel.
In SL903-P - SL-EM903 P and SL907 models,
before removing the grease filter, you need
to open the central panel, which is lighted in
SL907 model , by turning it downwards as
shown in Fig. 1.
It can be removed by pushing its special han-
dle toward the backside of the coo-ker hood
and turning the filter downwards so to unfa-
sten it from its slot. To insert the filter just
perform the opposite operation.
After 30 hours working (SL903-P and SL
EM903-P), the push button control panel will
signal the saturation of the grease filter by
lighting all the buttons.
Press the timer button to reset
The grease filter needs cleaning by regular
hand-washing or in dishwashers every two
months at least or depending on its use.
* In case the appliance is used in its filtering
version, the active coal filter
needs to be periodically replaced. The coal
filter can be removed by removing the grease
filter first, and by pulling its special plastic
tongue until it is un-fastened from its slot.
Reinsert the coal filter by operating in the
opposite way. The coal filter needs replacing
depending on the use, but however every six
months at least.
To clean the appliance itself tepid water and
neutral detergent are recommended, while
abrasive products should be avoided.
To replace the halogen lamps, remove first
the glass-blocking ring (Fig.12A), by levering
with a screw-driver and thus removing the
opaque glass (Fig.12B) - when performing
this operation hold the opaque glass careful-
ly. Remove the lamp (Fig.12C) without tou-
ching it with uncovered hands. Replace it with
another lamp of the same kind. After the re-
placement, re-insert the glass-blocking ring
and fasten it.
Square lamps
To replace the bulbs in the square lights,
press the light frame where it says "PUSH"(Fig.
13 and Fig. 14), then replace the bulb and
press the frame back into place.
To replace the round or square LED lamps,
you have to check first if it is possible to ac-
cess the back side of the lamp with your hand
(Pic. 20).
If it is possible to access the back side of the
lamp, you have to: insert your hand , push
at the same time both support wings of the
lamp (Pic. 21), push to remove the lamp (Pic.
22).
If it is not possible to access the back side of
the lamp, you have to: provide yourself with
a sharp utensil, insert the utensil between the
lamp and the stainless steel frame (on the
side where the little support wings are pla-
ced), push to remove the lamp from the coo-
ker hood (Pic. 23).
Replacement of SL 907 fluorescent lamp
To replace the fluorescent lamps of SL907
model, you need to open the perimeter pa-
nel, by rotating it as shown in Fig. 1, remove
.
the panel fixing screws (fig. 17), paying spe-
cial care in holding it during this step, then
remove the lamps and replace the damaged
one (fig. 18).
Insert the panel again.
If the supply cord is damaged, it must be
replaced by the manufacturer or its service
agent or a similarly qualified person in order
to avoid a hazard.
16