Power Limiter - Atag HIDD8472EV Gebrauchsanweisung

POWER LIMITER

Setting the power limiter should only be carried out by a registered and qualified
installer. Please read the safety regulations and the installation instructions
carefully.
The hob is equipped with a power limiter. If the total power of operating cooking zones exceeds
the maximum available amount of power, the power is automatically reduced. The display of the
cooking zone who is being reduced in its power is first flashing; the level is then automatically
reduced to the highest available power.
• The limiter is set at 7400W by the factory, but it is possible to change it to 2800W, 3500W or
4500W.
Power limiter configuration
Make sure there are no pots or pans on the hob before you start!
1. Disconnect the appliance from the main power supply by removing the power connector
from the socket, by removing the fuse or turning the circuit breaker off.
2. Reconnect the appliance to the power supply.
The keep warm key is flashing.
▷
• Perform, within 2 minutes after reconnecting the hob to the power supply, the
following steps.
• Make sure all cooking zones are switched off.
3. Touch and hold the keep warm key.
4. Then, touch each cooking zone key counterclockwise (start with the cooking zone key on
the front right).
5. Release the keep warm key.
▷ "C" is flashing alternately with "0" on the cooking zone display on the rear left.
The configuration value appears in the cooking zone display on the front left.
▷
EN 27