Filling The Rinse Aid Reservoir - ETNA VWV647WIT Bedienungsanleitung

USING YOUR DISHWASHER

Filling the rinse aid reservoir

1. Open the reservoir cap.
2. Carefully pour in the rinse-aid into its dispenser, whilst avoiding it to overflow.
3. Close the reservoir cap.
Note: Clean up any spilled rinse aid with an absorbent cloth to avoid excessive foaming
during the next wash.
Adjusting the rinse aid reservoir
To achieve a better drying performance with limited rinse aid, the dishwasher is designed to
adjust the consumption by the user. If the dishes are not drying properly or are spotted, select
a higher setting until your dishes are spot-free. Select a lower setting if there are sticky whitish
stains on your dishes or a bluish film on glassware or knife blades.
1. Switch on the appliance.
2. Within 60 seconds after step 1, press and hold the start/pause button for more than
5 seconds.
3. Press the delay button to enter the setting mode. The rinse aid indicator blinks.
4. Press the start/pause button to select the proper setting according to your using habits.
The settings will change in the following sequence: D1->D2->D3->D4->D5->D1. The
factory setting is D3.
5. Press the On/Off button to confirm the setting and to end the setting mode.
Setting
D1
D2
D3
D4
D5
Amount of rinse aid (ml)
1.2
2.4
3.6
4.8
6.0
EN 15