Herunterladen Inhalt Inhalt Diese Seite drucken

MO-EL 793N04 Gebrauch Und Wartung Seite 13

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 24
application sites. With high efficiency on heating from long distance,
a compact size and a light weight a wide range on installation can be
easy made. The comfort is immediate, no preheating is necessary
and this can give a large cost saving on wide air volume or where
there is discontinuous presence. The radiant heating give a pleasant
comfort and the absolute silence is assured without moving parts.
Without air movements there isn't the spreading of particles or dust.
Switch on the heater simply by connecting to the power supply.
Do not touch the metallic parts when the heater is working.
Ensure that the rays of the heater are directed towards the area it
is wished to heat. If necessary, change the angle of inclination by
loosening the screws of the support or the modules.
In unoccupied premises it is recommended that the heating system
is switched off by disconnecting from the electrical supply.
Avoid exposing skin to the rays of the appliance for distances
less than 50 cm.
Avoid exposing eyes to the rays of the appliance for distances
less than 2.70 m.
All users should be made aware of all aspects of operation and
safety and these instructions should be retained for reference.
5. MAINTENANCE
The IR Industrial Heaters contain no moving parts and therefore very
little maintenance is required other than to ensure that there is no
excessive build-up of dust/dirt on the reflectors or emitters as this
can cause overheating and premature emitter failure. To clean the
appliance, wipe off with a damp cloth. Wait until it is completely dry
before connecting to the power supply.
6. EMITTER REPLACEMENT
The emitters used in the IR heater are robust and if knocks and
shock vibrations are avoided, they will last for around 3000 hours.
They should be substituted even before if there are signs of aging.
Due to the special sealing and anti-shock design of the heater, the
emitters are not intended to be user replaceable. Please ensure that
all emitters are replaced via the Mo-El service network.
13

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis