Installation; Commissioning - Stahl 8561 Serie Betriebsanleitung

Commissioning

DE
6.2

Installation

EN
Operation under difficult conditions, e.g. on ships or in strong sunlight, requires additional
FR
measures to be taken for correct installation, depending on the operating location.
IT
Further information and instructions on this can be obtained on request from your
designated sales contact.
ES
RU
6.2.1 Conductor Connection
NL
DANGER! Explosion hazard due to incorrectly clamped down conductors!
Non-compliance results in severe or fatal injuries.
DK
▶
SE
▶
Select suitable conductors that do not exceed the permissible heating temperature within
FI
the enclosure.
▶
Pay attention to the prescribed conductor cross sections and specified tightening
PT
torques (for the conductor cross-sections and tightening torques, see "Technical data").
GR
▶
Guide the conductor insulation to the terminals (for the stripping length,
PL
see "Technical data").
▶
Do not damage the conductor when stripping the insulation (e.g. by denting it).
CZ
▶
Fit the core end sleeves properly using a suitable tool.
SK
▶
Use solid, stranded or finely stranded copper conductors.
▶
HU
Install a maximum of two conductors under one connection terminal. In the case of solid
conductors, make sure both conductors are made of the same material and have the same
SL
cross section.
RO
BG
LV
LT
EE
7 Commissioning
CH
Before commissioning, carry out the following checks:
KR
▶
Check the device for damage.
▶
Check whether mounting and installation have been performed correctly.
CN
▶
Remove any foreign objects.
▶
If necessary, clean the connection chamber.
▶
Check whether all the specified tightening torques have been observed.
8
Fuse element with fuse links
Series 8561
Do not use core end sleeves with plastic caps.
15
11534E00
149254 / 8561604300
2023-02-01·BA00·III·en·03