Switching Off The Appliance; Storage; Repacking For Private Transport Purposes - Rowi HKH 2000/2/1 ODT PREMIUM Originalbetriebsanleitung

Press the button again to return to stand-
by mode.
ATTENTION: The ventilator continues
running for 20 seconds until it switches
Press the button again to
off fully.
switch off the appliance (return to
Stand-by mode).
2. Setting the heating levels
Press the Mode button to toggle
between the heating levels:
Lo = Heating level 1 (1000 W)
HI = Heating level 2 (2000 W)
3. Oscillation
Press the Oscillation button to
switch on the oscillation function.
Press the button again to switch this
function off.
4. Thermostat
Press the "+" or "-" buttons to set the
desired temperature. You can select
between 6-35 °C.
The integrated
attempts to reach and maintain the set
temperature.
5. Timer
Press the Timer button. You can
now set the desired timer in 30
minute intervals with the "+" and "-"
buttons. You can select between 0-24 h.
Wait a few seconds after making the
selection. The timer is saved once the
display shows the room temperture/
heating level again. The flashing dot in
thermostat now
the display indicates that a timer has
been set.
The appliance switches automatically
into Stand-by mode after the set period.
4.3 Switching off the
appliance
1. Press the Power button on the control
panel. The blower now continues
operating for about 20 seconds to cool
the heating element down.
2. Then operate the main switch (Fig. 1,
No. 6) on the rear of the appliance to
switch it off fully.
3. Pull the power plug out of the socket.
Attention danger!
Wait until the appliance has cooled
down before covering it or putting it
away.

4.4 Storage

Protect the appliance against dust, dirt
and insects. Cover the appliance with the
sheet provided so that it is protected from
impurities and damage or malfunctions
caused this.
Attention danger!
Wait until appliance has cooled down
before covering or putting it away.
4.5 Repacking for private
transport purposes
Always pack the appliance in its original
packaging for transportation to prevent
transport damage.
GB
27/48