Disposal And Recycling; Replacing The Power Cable; Cleaning, Maintenance And Ordering Of Spare Parts - EINHELL 43.211.16 Originalbetriebsanleitung

Anleitung_TC_JS_80_SPK1__ 19.11.13 10:41 Seite 15
6.5 Making cuts
Ensure that the ON/OFF switch (3) is not
n
depressed. Only then should you connect the
mains plug to a suitable socket.
Do not switch on the jigsaw until you have fitted a
n
saw blade.
Use only saw blades that are in perfect condition.
n
Replace blunt, bent or cracked saw blades
immediately.
Place the saw foot flat on the workpiece you wish
n
to saw. Switch on the jigsaw.
Allow the saw blade to accelerate until it reaches
n
full speed. Then slowly move the saw blade along
the cutting line. Only exert gentle pressure on the
saw blade as you do so.
When cutting metal, apply a suitable coolant
n
along the line you wish to cut.
6.6 Sawing out sections (Fig. 10)
Drill a 10 mm hole in the section you wish to saw out.
Insert the saw blade into this hole and start to saw out
the required section.
6.7 Making parallel cuts
Mount the parallel stop and adjust as required
n
(see section 5.3).
Observe the instructions in section 6.5.
n
Cut as shown in Figure 11.
n
6.8 Making miter cuts
Set the angle on the soleplate (see section 5.4).
n
Observe the instructions in section 6.5.
n
Cut as shown in Figure 12.
n

7. Replacing the power cable

If the power cable for this equipment is damaged, it
must be replaced by the manufacturer or its after-
sales service or similarly trained personnel to avoid
danger.
8. Cleaning, maintenance and ordering
of spare parts
Always pull out the mains power plug before starting
any cleaning work.
8.1 Cleaning
Keep all safety devices, air vents and the motor
n
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
We recommend that you clean the device
n
immediately each time you have finished using it.
Clean the equipment regularly with a moist cloth
n
and some soft soap. Do not use cleaning agents
or solvents; these could attack the plastic parts of
the equipment. Ensure that no water can seep
into the device.
8.2 Carbon brushes
In case of excessive sparking, have the carbon
n
brushes checked only by a qualified electrician.
Important! The carbon brushes should not be rep
laced by anyone but a qualified electrician.
8.3 Maintenance
There are no parts inside the equipment which
n
require additional maintenance.
8.4 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
Type of machine
n
Article number of the machine
n
Identification number of the machine
n
Replacement part number of the part required
n
For our latest prices and information please go to
www.isc-gmbh.info

9. Disposal and recycling

The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to
the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as
special waste. Ask your dealer or your local council.
10. Storage
Store the equipment and accessories out of children's
reach in a dark and dry place at above freezing
temperature. The ideal storage temperature is
between 5 and 30 °C. Store the electric tool in its
original packaging.
GB
15