Built-In Installation - Klarstein Botella 166 Uno Bedienungsanleitung

• Positioning the appliance requires two people in order to avoid injuries or damage
to the appliance.
• Your appliance should not be located in direct sunlight or exposed to continuous
heat or extremes of temperature (e.g. next to a radiator or boiler). If this is not
feasible, then you should install an insulation plate between the appliance and the
adjacent heat source.
• You should check whether there is an electrical socket available, which will be
accessible after your appliance is installed.
• Place the appliance flatly and firmly on a solid base. The appliance is fitted with
adjustable feet on the front side, which can be used to level the appliance.
• When the wine cooler is being used as a freestanding unit, anything positioned
above the appliance must be at least 10 cm away to allow sufficient cooling of the
condenser. You must allow a 5 cm gap to the rear and either side of the appliance.
• Be sure to leave enough space for the opening of the door, to avoid damage to the
appliance or personal injury.
Note: The vent at the base of the appliance is for ventilation. Nothing should be
placed in front of this vent; otherwise your wine cooler may not operate properly.

BUILT-IN INSTALLATION

EN
33