Service And Replacement Parts; Inspection Plan - Hailo 8050 Serie Gebrauchsanleitung

10. Service and replacement parts

You can find these instructions for use on the
internet at www.hailo.de.
HAILO-Werk
•
Tel.: +49(0)2773 82-0
E-mail: info@hailo.de

11. Inspection plan

During the regular inspection of the ladder, inspection points 1- 7
should be taken into account. If any of the tested points cannot
be fully satisfied, you should NOT use the ladder.
Regular inspection by a qualified person is required for
commercial use.
(Overview of the inspection items [illustration], see page 5 .)
1. General inspection points
Are there any contaminants (e.g., dirt, mud, paint, oil or grease)
on the ladder? All fastenings (rivets, screws, bolts, etc.) must
be completely present.
Are any fastenings possibly loose or corroded?
2. Ladder side, ladder steps
Are ladder sides and reinforcement strips possibly bent,
curved, twisted, dented, torn, corroded or rotten?
All ladder steps must be completely present. Are ladder steps
possibly worn out, loose, corroded or damaged?
3. Platform with locking latches, joints, hinges
Check the function, strength and completeness as well as for
damage and corrosion.
4. Ladder feet
Check feet for stability, wear and signs of damage. All ladder
feet must be present.
5. Safety braces
Are there any damages or cracks visible on the tensioning
rope? Are the attachment points in good condition?
6. Safety rail / multifunction tray
Are damage or cracks present?
7. Ladder labels
Are all labels present and perfectly legible?
Daimlerstr. 8
Fax: +49(0)2773 82-1239
•
www.hailo.de
•
- 19 -
35708 Haiger, Germany
•
en