EUROM 48 Anleitungsbroschüre Seite 10

i.e. concrete, wooden beams or similar but not plaster, soft boards, scrap etc. able to
bear at least 100kg.
Ceiling fan
Your ceiling fan should be installed by someone with an understanding of electrical cabling.
• Disconnect the power.
• Remove the packaging materials.
• Screw the three turbines to the motor casing securely with 2 nuts and rings each; the
connection bracket should face the ceiling (see diagram).
• Secure the plate with the suspension hook to the
ceiling, directly next to the electrical connection point.
- Decide which screws (and plugs or bolts) are
required for your base material. The materials
which are enclosed are suitable for wood. If you
have another base and you are not sure, ask for
advice regarding which materials are required!
- Mark the right location for the screws. If
necessary, drill holes and use plugs/key bolts.
- Screw the plate (suspension hook downwards)
into place securely. Use a flat ring and a spring
washer between the screw and plate for extra
rigidity. Make sure no wires are trapped between
the ceiling and the plate!
• Slide the upper protective cap on the fan downwards
and hang the fan on the suspension hook using the
pulley. Make sure that no wires become trapped
between hook and pulley!
Check to make sure that everything is secure.
• Connect the wires from the connection
point to the corresponding wires in the
connector: Brown = L (phase), Blue = N
(neutral), green/yellow
Important! Do not switch any wires; this
will damage the device!
• Slide the upper protective cap over the
connection point and hanging point to the
ceiling and screw it into place onto the
piping.
.
.
10
= earth.